08-11-2010 11:08 AM - edited 03-11-2019 11:24 AM
What would be the easiest way to do the upgrade? I think I would have to do two interim upgrades first so is it possible to just reimage the device with 8.0(4) and apply the configurations from there? Sorry for the newb question but I don't ever deal with updating firewalls.
Thanks!
08-11-2010 11:16 AM
Hello,
You could do it as long as you don't mind reconfiguring the device. Also, if
you do not have any conduits/alias commands, then it should be fine. You
might have to do some configurations based on the features you have enabled.
Hope this helps.
Regards,
NT
08-17-2010 01:51 PM
Thanks! We are good with memory etc requirements. I think we're going to go with the incremental upgrades because it seems less likely for something major to go wrong.
08-11-2010 12:24 PM
One thing you may want to double check is that you have enough resources for upgrade. I.E. you are running a PIX 515 or higher and have the necessary memory amounts.
This document should have some more information.
http://www.cisco.com/en/US/docs/security/asa/asa70/pix_upgrade/upgrade/guide/pixupgrd.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide