Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
554
Views
0
Helpful
1
Replies

Upgrading ASA from command line

smsialane
Level 1
Level 1

‎01-25-2007 09:28 AM - edited ‎02-21-2020 01:23 AM

I've upload a new flash image to my ASA and can see it when doing a "Sh Flash" command.

However, we rebooting it is not used. What is the proper procedure to get it to use an image file?

Would I use...

boot system flash:/asa722-k8.bin

We are currently using 7.02 (disk0:/asa702-k8.bin)

0 Helpful
1 Reply 1

bwilmoth
Level 5
Level 5

‎01-31-2007 02:06 PM

The issue is due to the boot option that you have mentioned in the ASA. This boot option determines the boot image when the ASA boots.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card