01-09-2024 08:32 AM
Hello,
How can I see the external IP's that are configured on an ASA via the CLI?
Thanks,
Solved! Go to Solution.
01-09-2024 08:39 AM
@Xavier Jackson are you referring to IP addresses assigned to the outside interface? You can run "show ip address" to show the IP address and determine which belongs to the "outside" interface.
If you are referring to external addresses used for NAT, then run "show nat detail" or "show run nat" to reveal the this information.
01-09-2024 08:38 AM
show interface ip brief
this list the interface and IP assign to it
MHM
01-09-2024 08:39 AM
@Xavier Jackson are you referring to IP addresses assigned to the outside interface? You can run "show ip address" to show the IP address and determine which belongs to the "outside" interface.
If you are referring to external addresses used for NAT, then run "show nat detail" or "show run nat" to reveal the this information.
01-09-2024 08:42 AM
Thank you, I found it.
01-09-2024 12:42 PM
show ip
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide