I'm trying to set up a virtual NGFW/FTD in our lab environment. I wanted it to be a stand alone system and not have to set up a separate manager. However, when I try to enable the local manager, I receive the following error:
"This device does not support local management."
Is there something that I'm missing or something special that I need to do? Or is local management truly not available with the virtual NGFW appliance?
Had same issue in my lab and it seems, that data sheet is little bit misleading. According to development guide, virtual devices do not have web interfaces, you must use the CLI to register a virtual device to a Cisco Firepower Management Center, which can be physical or virtual.