08-09-2005 06:38 AM - edited 02-21-2020 12:19 AM
I am looking for configuration examples on setting up VLAN-based virtual interfaces with a PIX 506e and a 2950 switch.
I need a DMZ on this PIX, and noticed this option.
HAs anyone set this up before?
08-09-2005 06:51 AM
well i did that on 515, it works but you only gain 2 more ifaces..
that is if you have 5 physical you can have max 3 virtual.
examples are on this website (at least i've found it here).
which OS do you have on Pix?
08-09-2005 07:31 AM
6.3
I couldn't find anything here. A lot on VLAN's but not configurating the PIX using the Virtual VLANS
08-16-2005 10:40 AM
Hello,
Here are is an example on how to do this in version 6.3.4:
interface ethernet1 vlan18 logical ---> map physical if to virtual if
nameif vlan18 web-host security70 ---> asign name to virtual if, include security level
ip address web-host 192.168.150.1 255.255.255.0 ---> asign IP address to virtual if
Remember the port connected in the switch for the PIX must be setup as trunk port.
Regards,
Carlos Roque
04-26-2010 01:13 AM
Hi there,
will each vlan in pix 515 will support its own dhcpd service
04-26-2010 04:20 AM
Yes, you can configure each PIX interface with dhcpd service. The dhcpd configuration is normaly per interface.
Here is the command reference:
http://www.cisco.com/en/US/docs/security/pix/pix63/command/reference/df.html#wp1025497
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide