06-11-2005 05:16 AM - edited 02-21-2020 12:12 AM
I have a PIX 501 in Denmark. A VPN concentrator in the UK and the US.
I have a LAN IPSEC tunnel from the UK to Denmark and from the UK to the USA.
From the UK I can connect to Denmark and to the USA, but I cannot connect from Denmark to the USA (via the UK).
What do I need to do to route accross the tunnels that have been created in the UK to allow the traffic to route between Denmark and the USA.
06-16-2005 11:18 AM
The following documents will help you in configuring LAN to LAN Tunnels on a VPN Concentrator.
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008009442e.shtml
06-16-2005 11:58 PM
Thanks for the information, but the links only show a 1 to 1 tunnel. I need to understand the scenario where I have three devices. Device 1 is a PIX, device 2 and 3 are VPN concentrators. I need to route tunneled traffic from device 1 to device 3 via device 2. At the moment device 1 and 2 can communicate, and device 2 and 3 can communicate, but device 1 cannot communicate to device 3 via the tunnels.
The tunnels are between device 1 and 2, and between device 2 and 3. I do not want to have to create a separate tunnel from 1 to 3, because this explanation here, is a simplification of a much larger network.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide