09-12-2011 04:28 AM - edited 03-11-2019 02:23 PM
Hi all,
we are experiencing performance issues on ASR 1004 with ZBF as our campus edge router.
Symptoms:
- sending small packets from inside zone to outside zone, for example UDP packets without payload
- this way I can generate up to 150.000 pps traffic (testing with packeth software, but we have had a real example with some kind of worm/virus)
- CPU load is about 1% (yes one!) to 2% all time !! (weird)
- ASR response to pings rises very quickly up to 5 seconds which makes box unusable dropping everything what goes through ZBF (so internet connection is gone)
- if I do the ping directly from box, it seems to work fine (no rules from self to outside zone in ZBF)
- if I remove interfaces from inside and outside zone (so disabling ZBF) and do the test again, ASR response goes from normal (0.2ms) up to 2ms (still sending 150.000 pps) and everything seems to work fine)
Config:
- two inside interfaces
- one outside interfaces
ZBF:
Policy Map type inspect IN2OUT
Class I2O-DENY
Drop log
Class I2O-SSH
Inspect TCP12H
Class I2O-PERMIT
Inspect NORMAL
Class class-default
Drop log
Policy Map type inspect OUT2IN
Class O2I-FTP
Inspect
Class O2I-H323
Inspect
Class O2I-DNS
Inspect
Class O2I-SSH
Inspect TCP12H
Class O2I-PERMIT
Inspect NORMAL
Class class-default
Drop
The most campus traffic to internet goes through class "I2O-PERMIT" with inspection:
show class-map ty inspect I2O-PERMIT
Class Map type inspect match-any I2O-PERMIT (id 1)
Match protocol ftp
Match protocol sip
Match protocol icmp
Match protocol tcp
Match protocol udp
Match access-group name I2O-PERMIT
show parameter-map type inspect NORMAL
parameter-map type inspect NORMAL
log dropped-packet off
audit-trail off
alert on
max-incomplete low unlimited
max-incomplete high unlimited
one-minute low unlimited
one-minute high unlimited
sessions rate low unlimited
sessions rate high unlimited
udp idle-time 30 ageout-time 30
udp halfopen idle-time 30000 ms ageout-time 30000 ms
icmp idle-time 10 ageout-time 10
dns-timeout 5
tcp idle-time 3600 ageout-time 3600
tcp finwait-time 5 ageout-time 5
tcp synwait-time 30 ageout-time 30
tcp max-incomplete host unlimited block-time 0
sessions maximum unlimited
gtp permit error off
gtp request-queue 40000
gtp tunnel-limit 40000
gtp gsn timeout 30
gtp pdp-context timeout 30
gtp request-queue timeout 60
gtp signaling timeout 30
gtp tunnel timeout 60
According to Cisco Datasheets: routing, Qos, Zbf ... on ASR 1000 with RP1, ESP10 should be done in hardware with up to 17.000.000 pps performance (and our box can kill only 150.000 pps)
Any ideas what could be worng?
Thank you for your suggestions.
Regards
Pavel
09-29-2011 08:13 AM
Hi Pavel,
Any news yet on this problem? Or even better, a solution? I'm having the exact same thing. Firewall enalabled = no performance...
Thanks for your update.
KR,
Jan