This document explains the solution for the error message %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface <interface> Power Controller reports power Imax error detected.
Power Imax / Tstart errors may be reported with some third party PDs.
%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,Interface <interface>
Power Controller reports power Imax error detected.
Sep 21 22:25:13.675 GMT:%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface Fa0/15: Power Controller reports power Imax error detected
You are hitting the bug CSCsw18530 : Power Imax / Tstart errors may be reported with some third party PDs
This error indicates that PD is drawing over-current more than allowed/supported per IEEE 802.3af standard. Seen with some of the 3750,3750G,3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C switches.
This issue is fixed in 12,2(55)SE3 , 12.2(58)SE1 and later releases. The following interface configuration commands have to be applied
to resolve the issue,
Switch(config)# int x/y
Switch(config-if)# power inline port 2x-mode
Switch(config-if)# no shut
The fix is present in the following platforms only : 3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C.The other platforms
do not support 2X power mode and the workaround would be to use a longer cable.Possible workaround is using Longer cable (>50ft)
In a medium-sized enterprise network, let's say you have a pair of datacenter switches, a pair of distribution switches, a pair of internal core routers, a pair of firewalls, and a pair of edge routers running BGP connected to the Internet.When designing&...
I have a one lab environment. I trying to redistribute rip and ospf. Rip network inject from 2 sides routers 3 and 4 , I applying the Route-map to TAG the injected routes from both.But I figure out some OSPF Routes (10.10.10.0 and 192.168.25.0) networks a...
Workstation tries to obtain IP address sending DHCP request. Unfortunately it does not see any response from DHCP server although server is up and running, router interfaces are up and ICMP communication is possible. Why is this happens and how to elimina...
Router R1 have to establish connectivity with router R2 loopback26 interface. Which route R1 will choose as first one, which as second and third ?Note: there is no route redistribution configured between protocols on any of the routers.