The ability to use a router as a TFTP server can be quite useful. We have often used this feature to upgrade several routers that are separated from the TFTP server by slow WAN connections. In situations like this, you can upgrade one of the remote routers by using TFTP over the slow WAN connection. Then you can configure the first router to act as a TFTP server, and use it to upgrade the remaining routers over high-speed local links.
The router is not a fully functional TFTP server. It can only serve files for download. You cannot use this feature to upload files into the serving router's local flash. However, the router is not limited to just serving IOS images. You can use your router's flash to store configuration files and make them available for download via TFTP as well. Moreover, you can even use it to hold configuration files for nonCisco equipment.
The "tftp-server" command use to configure the router to act as a TFTP server:
Enter configuration commands, one per line. End with CNTL/Z.
hi,we have an HSRP but the firmware of standby switch is not updating from TFTP server showing time out and when we login from WEB GUI we can only able to login as monitor mote there is nothis we can configure.
We tried to insert a new stack member - the primary - into a stack. I wasn't there to see the precise order cabling and power on. Butmy understanding is that racking the replacement primarystack member and cabling it up as the previous primary s...
Greetings - I ordered 1GB Ethernet DIA for three different sites. Each site was delivered with a fiber handoff, instead of an Ethernet handoff. Now the carrier is wanting to charge extra for the media converter for each site. W...
Hello , I use this command to set Preference = LTE .cellular 0/2/0 lte technology lteAfter this command it change to LTE . cisco_1117#show cellular 0/2/0 radio
Radio power mode = online
LTE Rx Channel Number = 550
LTE Tx Channel Numb...
Ive tried to configure Dhcp on my Lan A computer by it keeps on failing can someone walk me through on what I should doRouter(config)#ip dhcp pool LanARouter(dhcp-config)#network 126.96.36.199 255.255.255.0Router(dhcp-config)#default-router 188.8.131.52Router(dhcp-c...