When a PC is connected to a switch port, firstly the port issues an 802.1x authentication challenge to the attached device (the 802.1x supplicant). The supplicant replies with username and password and then an authentication request is passed to a configured Radius server.
The error message can look similar to this:
%DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [mac address] on Fa0/10
This means that the supplicant MAC address cannot be added. This can happen when the TCAM is full or the address exists as a secure address on another port.
The message can come from the port-security subsystem. In some cases, these messages are generated by switches that run Cisco IOS Software Release 12.2(25)SEE2.
If this message appears only once, then this can be ignored.
In order to resolve this issue, if the hardware is full, remove some Dynamic addresses with the clear mac address-table command, which are automatically added to the address table and dropped from it when they are not in use.
If the supplicant address is secured on another port, manually remove it from that port with the clear port-security command.
Can someone help me with determining the heat dissipation of Cisco IE-3300-8T2S-E for the purposes of calculation temperature rise inside the enclosure in which it is to be housed? The datasheet just lists a power consumption of 23 W at 12 V (N...
Hi, I need to change (not reset) the password for "admin" user but receive this error: prime/admin(config)# username admin password plain PASSWORD role ?network-admin Specifies user with network admin role privilegessecurity-admin&n...
I have a 24port 2960-L (running the latest IOS) which being passive cooled fits my requirement well. I have configured it with a number of VLANs with a SVI on each and enabled routing. Seemingly at random an SVI stops responding. Unfortunately I...
Hi Team,I need help to choose a Router to handle my scenario.My scenario is, i have 2 WebServers with 2 Static IPs from different SUBNETS.I have a VIRTUAL IP mapped to my website www.abc.com.Now i want to loadbalance my website url https://www.abc.c...
Hi All, I've been having a harder time now dealing with Cisco. I ordered Adventerprise license for my ASR router. Unfortunately, was sent license for Advipservices. I only found out when I installed what I thought was license for interface_10g, only ...