When a PC is connected to a switch port, firstly the port issues an 802.1x authentication challenge to the attached device (the 802.1x supplicant). The supplicant replies with username and password and then an authentication request is passed to a configured Radius server.
The error message can look similar to this:
%DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [mac address] on Fa0/10
This means that the supplicant MAC address cannot be added. This can happen when the TCAM is full or the address exists as a secure address on another port.
The message can come from the port-security subsystem. In some cases, these messages are generated by switches that run Cisco IOS Software Release 12.2(25)SEE2.
If this message appears only once, then this can be ignored.
In order to resolve this issue, if the hardware is full, remove some Dynamic addresses with the clear mac address-table command, which are automatically added to the address table and dropped from it when they are not in use.
If the supplicant address is secured on another port, manually remove it from that port with the clear port-security command.
I have a 7206VXR running Version 12.4(12.2r)T. I have an openfire XMPP server that needs to have port 5222 forwarded. Server is 10.5.7.18. G0/1 is my WAN interface I tried ip nat inside source static tcp 10.5.7.18 5222 int g0/...
I want to block some ip on my network, this IP are primary IP in my Network (Some Devices has a default IP's i have many vendor devices that has same IP binded i want to Block on my network) One Devices is connected on FA2/5 (IE 115 Switch...
Dear Team, I have setup as per attached diagram. I have two sites that is SITE-1 and SITE-2. The SW1 is Layer switch installed at my SITE-1 and SW2 is the layer 2 switch installed at my SITE-2. I want to configure the fail-over at Layer 2 so that traffic ...
Hello,we have been using cisco sg250-26 for couple of months now. We have just bought another SG250-26 Switch for high-availability. I was told that there are 2 possible ways to achive high-abailability: hot standby and cold-standby..Do you guys have a ma...
Hi All, I'm planning to use a ASR 1009-X router with 40Gbit connections (80Gbit throughput) and I would like to know whether any performance licenses are needed?Also do you know any documentation regarding the Cisco licensing? What kind of possible l...