This topic is a chance to discuss more about the implementation and troubleshooting of Virtual Switching system (VSS) on Cisco Catalyst Switches, particularly on 4500, 6500 and 6800 Virtual Switching System (VSS) is network system virtualization technology that pools multiple Cisco Catalyst 6500 Series Switches into one virtual switch, increasing operational efficiency, boosting nonstop communications, and scaling system bandwidth capacity to 1.4 Tbps. At the initial phase, a VSS will allow two physical Cisco Catalyst 6500 Series Switches to operate as a single logical virtual switch called a virtual switching system 144.
This session provides an opportunity to learn and ask questions about how to implement, configure and troubleshoot VSS in Cisco Catalyst Switches.
Ask questions from Monday 11th to Friday 29th of June, 2018
InayathUlla Sharieffis a Customer support engineer in High-Touch Technical Services (HTTS) team supporting LAN Switching and Data centre Products. His areas of expertise include Cisco Catalyst 2000,3000,4000 ,6500 and Cisco Nexus 7000 Switches. Shariff has over 10 years of industry experience working with large enterprise and Service Provider networks. He holds a Bachelor’s Degree in Computer Sciences and the following Cisco certifications: CCNA, CCNP (in Routing and Switching), and CCIE in R&S (# 43263).
Atul Choudharyis a Customer Support Engineer in High-Touch Technical Services (HTTS) at Cisco Bangalore, India. He has over 5.5 years of industry experience working with large Enterprise, Security and load balancers. He has been working with HTTS from past 2 years and supporting LAN Switching Products. His areas of expertise include Cisco Catalyst 2000, 3000, 4000, 6000, and 9000 Catalyst Switches. Atul holds a Bachelor's Degree of Sciences in Electrical and Electronics Engineering from Maharshi Dayanand University and he is pursuing a Masters of Technology in Software Systems from BITS, Pilani. He hold several certifications such as, JNCIA-Junos, JNCIS-ENT, JNCIP-ENT and he is pursuing a CCIE R&S.
InayathUlla and Atul might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Contact Center Community
Hi all.I have a cisco 1921 router with the following interface configuration. interface Embedded-Service-Engine0/0no ip addressshutdown!interface GigabitEthernet0/0description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$ip address 10.139.1.25 255...
I am configuring configuring circuit over DWDM NCS 2006 network.I created all internal and network patch cords as expected, but I keep receiving message A valid route cannot be found for circuit creation request. Any idea?
Hi all, How do i select the IOS in flash amongst the three in Cisco Catalyst 4948E Switch. I have set the boot flash of that particular IOS but whenever switch restart it loads the 1st one in auto. Kindly help in changing the priority of IOS / Flash ...
ear All, I wanted to check latency of Nexus 93180YC-FX as per data sheet it says latency is 1 microsecond. Our requirement is to reduce to the same to nano second is there any license available for the same? where we can install t...
I have an ISR 4451 running ios 15.5(2)S1c. It has a number of eBGP peers which have been working fine for ages. Ive added a new BGP peer simply viarouter bgp <my-as> bgp log-neighbor-changes neighbor 10.66.250.202 remote-as 120...