Showing results for 
Search instead for 
Did you mean: 

Cisco Router ISR-4331 Show interface output interval issue?

Ask Me Anything (Formerly known as Ask the Expert)

Dear All,


When I use the show interface command on the Cisco Router ISR-4331, it will display as below information. The word that I mark red, it refresh every 5 seconds. But, I compare with the old router model like a Cisco 29XX or 28XX, it can be refresh every 1 second. Is there anyone know how to change the refresh interval on Cisco router 4331 ("bootflash:/")?



#sh int g0/0/0 
GigabitEthernet0/0/0 is up, line protocol is up 
Hardware is ISR4331-3x1GE, address is 2cab.eb85.91a0 (bia 2cab.eb85.91a0)
Internet address is
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec, 
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not supported 
Full Duplex, 100Mbps, link type is force-up, media type is RJ45
output flow-control is on, input flow-control is on
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:04, output 00:06:58, output hang never
Last clearing of "show interface" counters never
Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 95000 bits/sec, 87 packets/sec
30 second output rate 80000 bits/sec, 61 packets/sec
511816539 packets input, 75629622593 bytes, 0 no buffer
Received 1465 broadcasts (161977042 IP multicasts)
0 runts, 0 giants, 0 throttles 
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 162302013 multicast, 0 pause input
76183480 packets output, 12080277968 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out 

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards

This widget could not be displayed.