cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
16000
Views
5
Helpful
0
Comments
TCC_2
Level 10
Level 10

Core issue

The media type does not appear, or is blank in the output of the show interface status command. However, the interface works fine and there are no connectivity issues.

These are some of the reasons for this problem:

  • A non-Cisco Gigabit Interface Converter (GBIC) is used.
     
  • The GBIC contains some erroneous reading of the IDPROM.
     
  • The interface is configured as a Layer 3 (L3) interface.

Resolution

Verify the serial number on the GBIC to ascertain that a Cisco GBIC is used.

If the switchport command is issued to configure the interface as an L3 interface, physically take out the GBIC and then insert the GBIC back into the slot. Then issue these commands:

These commands must now display the GBIC type.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: