cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
403688
Views
42
Helpful
17
Comments
SunilKhanna
Level 1
Level 1

     

    Introduction

    Extended Unique Identifier (EUI), as per RFC2373, allows a host to assign iteslf a unique 64-Bit IP Version 6 interface identifier (EUI-64). This feature is a key benefit over IPv4 as it eliminates the need of manual configuration or DHCP as in the world of IPv4. The IPv6 EUI-64 format address is obtained through the 48-bit MAC address. The MAC address is first separated into two 24-bits, with one being OUI (Organizationally Unique Identifier) and the other being NIC specific. The 16-bit 0xFFFE is then inserted between these two 24-bits for the 64-bit EUI address. IEEE has chosen FFFE as a reserved value which can only appear in EUI-64 generated from the an EUI-48 MAC address.

    Here is an example showing how a the MAC Address is used to generate EUI.

     

    pic1.bmp

     

    Next, the seventh bit from the left, or the universal/local (U/L) bit, needs to be inverted. This bit identifies whether this interface identifier is universally or locally administered. If 0, the address is locally administered and if 1, the address is globally unique. It is worth noticing that in the OUI portion, the globally unique addresses assigned by the IEEE has always been set to 0 whereas the locally created addresses has 1 configured. Therefore, when the bit is inverted, it maintains its original scope (global unique address is still global unique and vice versa). The reason for inverting can be found in RFC4291 section 2.5.1.

     

    pic2.bmp

    Once the above is done, we have a fully functional EUI-64 format address.

     

    Another doubt or frequently asked question is, are IPv6 devices (routers etc) today doing anything to that universal/local bit? Currently, nothing is being done be the U/L bit 1 or 0. However, per RFC4291 2.5.1 (The use of the universal/local bit in the Modified EUI-64 format identifier is to allow development of future technology that can take advantage of interface identifiers with universal scope), this may change in the future as the technology evolves.

     

    Note: The command to assign an IPv6 EUI-64 format address is {ipv6 address ipv6-prefix/prefix-length eui-64}

    Example

    edpic1.bmp

     

    edpic2.bmp

    References

    IPv6 Autoconfiguration

    Cisco IOS IPv6 Command Reference

    Comments
    jeisanch
    Level 1
    Level 1

    EUI-64 IPv6 addresses are generated from MAC addresses by taking the network prefix (64 bits) and appending the first half of the MAC address, then FF:FE, then the second half of the MAC. Is there a reason for the FF:FE? Other than 64+64=128.

    thank you so much for sharing!

    Getting Started

    Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

    Review Cisco Networking for a $25 gift card