cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
77712
Views
49
Helpful
15
Comments
kaannadu
Beginner
Beginner

In this video we will see an example of how to configure InterVLAN routing on a Cisco catalyst 3550 series switch.

15 Comments
sniadmins1
Beginner
Beginner

Please provide United States-based groups with presenters who have U. S. English as a primary language.  We had to rewind this vid several times at several points because the presenter had such a thick accent and was very difficult to understand.

Thanks.

1ashlee2794
Beginner
Beginner

How doyou view theses videos?????

guptazeee
Beginner
Beginner

Which video format is this? I cannot play the video.

jeffreydansby
Beginner
Beginner

It uses Adobe Flash, should play in the browser.

JD

benny.lane
Beginner
Beginner

The setup looks straight-forward and the video is pretty easy to understand. However, the actual routing step (ip route 0.0.0.0 0.0.0.0 200.1.1.2) is missing from the video. Including that and a better explaination of the routing would make this document and video much better.

n.bedbury
Beginner
Beginner

If you posted a diagram of the network setup, that'd be handy.  For example, which switch ports connect to which host?

kamran2go
Beginner
Beginner

Crystel Clear presentation .

Even works with out default route. 

Thanks buddy.

vgoldenlev
Beginner
Beginner

why he using no shut command after configuring switchport access vlan 2 or 3

there is no need on this 

you have use NO SHUT when you configuring interface VLAN 

oliverhext
Beginner
Beginner

Great video!

tonpeopl
Beginner
Beginner

Thank you so much!  This was super easy to follow!

j.romo509
Beginner
Beginner

Great video and easy to follow.  The ip routing at the beginning was most helpful!

XWL
Beginner
Beginner

I used Packet tracer to do the testing, however, the 'IP Routing" is not available in any switch in the Packet Tracer.

I do not have physical hardware available for the testing.

If we need this command "ip route 0.0.0.0 0.0.0.0 200.1.1.2", then do we have to have a router on the stub. if a router is needed, then why need layer 3 switch?

PS:

I find that need select Multi-Layer Switch in the Packet Tracer.

It is working now, no need "ip route 0.0.0.0 0.0.0.0 200.1.1.2" command, no need Router -on-Stick 

It just works.

pierredacres
Beginner
Beginner

you don't need a default route.  he is showing inter-vlan routing not how to allow hosts to access the internet.  Since the routes are connected C* there is not need for a default just to speak to each other.

 

 

FIDELIO
Beginner
Beginner
Very helpful and clearly explained. Would be nice though if when the video is paused the screen doesn't get blurry.
mohammeda60
Beginner
Beginner

For clearer explanation on VLANs and Inter VLAN routing click on the link.

https://youtu.be/5hj4TaaJBdY

https://youtu.be/rCopMlBeXis

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links