This video demonstrates as to how one can perform a Day 0 Configuration on the Network Devices using the PnP (Plug and Play) feature and how this integrated with APIC-EM and Cisco Prime Infrastructure 3.0
Additional Prime Infrastructure 3.0 Videos can be found at :
Hi everyone, This is my first post here and I'm still learning the ins and outs of the network as it was set up before I arrived. So currently I have 3 SSID's set up for the school, SGC, Staff, and Student. I have a specific AP, a AIR-CAP3702I-Z...
Hello, I have a site to site VPN from my cisco asa’s to another customer - it works fine and both tunnels can ping the remote IP address I have routing to the customer subnets from my internal Layer 3 switchsw1-Layer3#ip route 10.108.x.x 255.255...
All my other phones say 3PCC in the model number. So will these phones work? and if so, how do I clear off the previous companies settings and passcodes? Or do I need to send these back and buy 3PCC phones only?
Hi team!I configuring ASA5506X with dual ISP obtaning ip addresses with dhcp...1. does this config looking correct?2. whay ASA doesn't accept both commands. dhcp-client client-id interface OUTSIDE
dhcp-client client-id interface YOTA