- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-05-2020 08:17 AM
I built two new package of type template. Edited the yang file and make clean all completed with no issues for both packages
Issuing the packages reload command I get:
>>> System upgrade is starting. >>> Sessions in configure mode must exit to operational mode. >>> No configuration changes can be performed until upgrade has completed. >>> System upgrade has been cancelled. Error: Internal error: {failed, {recompile_needed, "./state/packages-in-use/1/my-package/load-dir/my-package.fxs"}}
I deleted the packages/mypackage directory and then NSO repeats the above error, with the same error for the only remaining package.
Any thoughts on what could cause this? Oh and its version 5.3.0.1 btw. Thanks
Solved! Go to Solution.
- Labels:
-
Developer
-
DevOps
-
Other NSO Topics
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-05-2020 01:21 PM

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-05-2020 12:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-05-2020 12:44 PM
Hi Vleijon,
Yes I do have a few versions installed. I understood this not to be an issue if I kept them in separate directories.
The idea was to be able to spin up netsim's for different routers and test the services I have written against the different versions of NSO.
Thanks

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-05-2020 01:21 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-06-2020 05:46 AM
