07-24-2022 02:18 PM
Hi,
I have 3 APs connected to the network that are not being seen by the WLC but is connected and can read the MAC address from the switches. I need the serial numbers of the APs but I can't physically reach them (too high). If I were to give you the MAC addresses of these APs, could you tell me the serial numbers of them?
Solved! Go to Solution.
07-24-2022 04:25 PM
Ok it turns out the WLC was seeing the APs after all (my bad). just needed to run 'sh ap config general' to get it to show the serial numbers of the APs in question. All good now, thanks.
07-24-2022 04:14 PM
Not possible.
Do you have DNAC or Prime Infrastructure?
07-24-2022 04:25 PM
Ok it turns out the WLC was seeing the APs after all (my bad). just needed to run 'sh ap config general' to get it to show the serial numbers of the APs in question. All good now, thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide