12-20-2022 01:33 AM
Hi all,
Good day!
Hope you are well. I'm trying to find out commands to use to check the C9400 switches if it is still working as it should be.
I've run show tech command and the result is very long and I don't understand most of it.
Is there a list of commands I can use for me to check the hardware? e.g no dead port, ram, cpu, supervisor etc.
Cheers!
Solved! Go to Solution.
12-20-2022 02:20 AM
that is for full diagnosis when TAC asked to provide, basic test you can do as per the below document :
12-20-2022 02:20 AM
that is for full diagnosis when TAC asked to provide, basic test you can do as per the below document :
12-25-2022 09:41 PM
Thank you @balaji.bandi for your response. Appreciate it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide