PROJ

[NaoyaKun]

 WHY I CAN'T CONNECT MY WLAN TO THE SERVER ? LIKE IT ALWAYS SHOW SERVER REQ TIMEOUT? CAN YOU HELP ME?

[liviu.gheorghe]

Also in EDGE-RTR you should add 

ip route 192.168.0.0 255.255.0.0 gigabitEthernet 0/0/0

[liviu.gheorghe]

Also in CORE-SW you should add 

ip route 0.0.0.0 0.0.0.0 gigabitEthernet 1/0/22

[NaoyaKun]

thanks its 90% now. i will find the 10 % remaining.

[liviu.gheorghe · Accepted solution]

Read very carefully the PT Activity - you should configure the equipment and features exactly like it's asked. For example, the requirement for configuring static routes on the CORE-SW and EDGE-RTR is using a connected interface, not a next hop IP address. The requirement is written with a red colour. I didn't pay much attention at first to this detail, but I saw that it matters.

Another thing - the WLC-MgmtPC was initially supposed to connect to the WLC-Mgmt SSID. You moved this WLC-MgmtPC to a wired connection to the CORE-SW. I think this is another thing that might impact your overall score.

[NaoyaKun]

can i ask? why my address prefix 2001:db8:10::/64 lifetime 86400 says it incomplete command?

[liviu.gheorghe · Accepted solution]

The first parameter after lifetime is the Valid lifetime and the second parameter is the Preferred lifetime. The cli expects you to input both of the parameters not only one:

GTWY1(config-dhcpv6)# address prefix 2001:db8:acad:10::/64 lifetime ?

<5-4294967295> Valid lifetime (seconds)

GTWY1(config-dhcpv6)# address prefix 2001:db8:acad:10::/64 lifetime 86400 ?

<5-4294967295> Preferred lifetime (seconds)

[NaoyaKun]

where do you think the remaining 10%? i do the life time but i doesnt have any effect?

[liviu.gheorghe]

Do you have access to the Activity results? It seems to me like a good place to see what is missing from your lab.

[NaoyaKun]

i dont haveeeeeee accessssss

[NaoyaKun]

it didnt have effect on score but i already connect the wlc-mgmtpc to the core