can we configure UDC to both OSC in 15454 M6?

[mohammed.samman1]

Dears,

can we configure one port UDC to both SFP in the same TNCE. so we can transmitt the UDC traffic to both side west and east.

the objective is, I have a DWDM ring . there is ASR903 router in each access site and i want to make out band management for routers through OSC. to do that i will connect Router RSP port  to the UDC  but there is only one RSP port available.if it is doable, I will connect ASR903 RSP to UDC and from UDC to both OSC (point to multipoint).

[aymetwal]

Hi Mohammed,

We can configure two OSC on one TNCE, but only one can be used for UDC.

Please check below link for further details:

http://www.cisco.com/c/en/us/td/docs/optical/15000r10_0/ncs/controlcard_nodeconfig/guide/b_ncs_control_card_node_config/b_ncs_control_card_node_config_chapter_011.html?bookSearch=true#ID1287

Regards,

Ayman