DWDM Installation.

[atul_dalvi]

Dear All,

I. ONS 15454 DWDM: 1. AD-2C Module - 1546 TX,RX - 1546 TX,RX - EXP TX,RX - COM TX,RX2. OSCM Module - TX,RX.3. OPT-PRE - MON TX,RX - COM TX,RX - DC TX,RX .4. OPT-BST - MON TX,RX - COM TX,RX - OSC TX,RX - LINE TX,RX.5. TCC2P Active and Standby.6. 10 DME Module. II. ONS 15454 DWDM: 1. AD-2C Module - 1546 TX,RX - 1546 TX,RX - EXP TX,RX - COM TX,RX2. OPT-PRE - MON TX,RX - COM TX,RX - DC TX,RX .3. TCC2P Module - Active and Standby.4. 10 DME Module.

I would like to know that is it the right combination.

Client is looking for point to point connectivity for servers location at different location.

Regards

[rick.king]

Impossible to tell you this. You did not give enough specifics such as what the connectivity is for (i.e. G or FC etc), and especially the distance from site to site or more specifically the fiber characterization/loss. If you ran this in MetroPlanner, then you should be fine. If not, without the fiber loss info, the amp cards could be overkill. The other cards should be fine.

[atul_dalvi]

Dear,

We are implementing this setup for DISASTER RECOVERY. Basically we are looking for point to point link using ONS 15454 at both location.I joined this company very recently and I am very new to SDH.

I would like to know which all module's are required to build up a point to point link between two location.

Waiting for your reply.

[Tom Randstrom]

You need to verify the network using Cisco's Transport Planner (formerly Metro Planner). Work with a Cisco SE or optical reseller. They will need to understand your fiber network to confirm necessary circuit packs.