How do i get the tx/rx power values through snmp

[simon_ghost]

Thanks for reading.

With ASR/7609, i use 1.3.6.1.2.1.47.1.1.1.1.7 to get  tx/rx power senor's indexs,and use 1.3.6.1.4.1.9.9.91.1.1.1.1.4 to get their values.

But with CRS i neither get the indexs nor the values. So, how can i get the crs's tx/rx power values through snmp.Thanks.

ps. the result of show version: 

Cisco IOS XR Software, Version 6.1.4[Default]
Copyright (c) 2018 by Cisco Systems, Inc.

[mauro_b46]

Simon,

I have the same problem,

Do you have managed to solve it?

wait you response

Regards.!

[Shahid Ishaq]

Hello,

Try the following command.

show hw-module subslot 0/1  transceiver 0 status

[mauro_b46]

No, I need request power dBm by snmp,

The command is:

RP/0/RP0/CPU0:CRSX-XX-2#show controllers Te0/2/0/7 phy | include dBm
Sat May 2 23:53:24.889 arg
Tx power: 0.6068 mW ( -2.2 dBm)
Rx power: 0.1367 mW ( -8.6 dBm)

RP/0/RP0/CPU0:CRSX-XX-2#show ver
Sat May 2 23:54:38.235 arg

Cisco IOS XR Software, Version 6.1.4[Default]

With ASR/7609, i use 1.3.6.1.2.1.47.1.1.1.1.7 to get  tx/rx power senor's indexs,and use 1.3.6.1.4.1.9.9.91.1.1.1.1.4 to get their values.

But with CRS i neither get the indexs nor the values. So, how can i get the crs's tx/rx power values through snmp.

Thanks