auto-cut-through command on E&M module

[byungsung.jeon]

Hi everyone,

I have a question of auto-cut-through command on a cisco 3600 router.

I connected a cisco 3600 router to other band PBX with 2 E&M module on wink-start signaling and did auto-cut-through command each pots.

voice-port 1/0/0

auto-cut-through

Phone A(FXS) -- Router --- (E&M) --- PBX --- Phone B(FXS)

Phone-A calls Phone-B.

If PBX is not provide answer supervison or wink to the call, is call compeltion ?

Thanks.

[ssoberlik]

The command 'auto-cut-through' should allow the call to complete even if the PABX does not provide M lead response.