I give up! (g). I am running an ICS-7750 with CCM 4.1 (don't say it), with the MRP3-8FXS and an FXO-M1 module. The Gtwy is in H.323 mode of course, and works fine.
If a call comes in with both Number AND Name Caller ID (CLND and CLID) this information is passed properly to the phone and looks perfect.
If a call comes in with ONLY number (CLID) and no name, it is displayed as an un-identified number (with no information what-so-ever). I've tried 3 versions of IOS but to no avail.
My Version on the MRP is: 12.2(13)ZH2
Any help is appreciated!
My Config is:
-----------------------------------------------
interface FastEthernet0/0
ip address 10.0.0.244 255.255.255.0 secondary
ip address 10.99.1.1 255.255.255.0
speed 100
full-duplex
h323-gateway voip interface
h323-gateway voip h323-id MRP
h323-gateway voip bind srcaddr 10.99.1.1
voice-port 1/0
battery-reversal answer
input gain 2
no comfort-noise
cptone CA
timeouts call-disconnect 5
timeouts wait-release 5
connection plar opx 2099
caller-id enable
!
voice-port 1/1
battery-reversal answer
input gain 2
no comfort-noise
cptone CA
timeouts call-disconnect 5
timeouts wait-release 5
connection plar opx 2099
caller-id enable
dial-peer voice 100 voip
destination-pattern 20..
progress_ind setup enable 3
progress_ind progress enable 8
session target ipv4:10.99.1.6
dtmf-relay h245-alphanumeric
!
dial-peer voice 98 pots
destination-pattern 1..........
progress_ind setup enable 3
progress_ind progress enable 8
port 1/1
forward-digits all
supported-language EN
!
dial-peer voice 99 pots
destination-pattern 905......
progress_ind setup enable 3
progress_ind progress enable 8
port 1/1
forward-digits all
----------------------------------------------------