I have a problem with connecting with the PBX. The PBX phone cannot call the IP phone and neither can do the other way round. Just no response whatsoever. However, the E1 controller and the lines are up.
My config for 3662 is:
voice-card 2
!
ip subnet-zero
!
!
no ip finger
no ip domain-lookup
!
call rsvp-sync
controller E1 2/0
framing NO-CRC4
ds0-group 1 timeslots 1-15,17-31 type r2-analog r2-compelled ani
cas-custom 1
unused-abcd 0 1 1 1
country china use-defaults
answer-signal group-b 1
!
!
interface FastEthernet0/0
ip address 192.168.1.254 255.255.255.0
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
ip classless
no ip http server
!
!
voice-port 2/0:1
cptone CN
!
dial-peer cor custom
!
!
!
dial-peer voice 101 voip
destination-pattern 1111
session target ipv4:192.168.1.1
codec g711alaw
!
dial-peer voice 102 voip
destination-pattern 2222
session target ipv4:192.168.1.1
codec g711alaw
!
dial-peer voice 201 pots
destination-pattern 9T
port 2/0:1
prefix 9,
!
dial-peer voice 202 pots
destination-pattern ...
port 2/0:1
We changed the PBX settings, mostly the signaling part, but not too much with the dialing plan or some system parameters. The change is made according to a Cisco Web Docu for setting E1R2 with Lucent PBX, though county is different.
I also tried by using r2-digital r2-compelled, but with no use.
The cable is RJ-48-BNC.
Any one know how to change the setting of PBX? I think the only part may be wrong is the sinaling because we tried FXS phone to talk with IP phone and it worked.
Can we use E1 E&M sigaling? I think this should be simpler. But how to match the setting on router and PBX?
Pls. post reply or send email to zhao_shi@hotmail.com. Thanks a lot.
