How to enable call redirect or transfer (H.450.2) on MRP 200

[kbouchard]

Hi,

I noticed that my MRP 200 configured as H.323 gateway, does not support the call redirection or call transfer (H.450.2). I saw in documentation that the MRP is suppose to support this feature when it is not the transferring endpoint.

I would like to know the command line to enable the feature because it doesn't work by default. I tried a call between PSTN and H.323 endpoint, everything works except when the H.323 endpoint invoke the call redirection or transfer, MRP doesn't react.

thanks a lot.

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.