Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
312
Views
0
Helpful
2
Replies

Networking Nortel Norstar with Cisco 1760

norman.chen
Level 1
Level 1

‎11-21-2004 04:30 PM - edited ‎03-13-2019 07:06 AM

I got a Nortel Norstar PBX, one at my host site and the other at my remote site. There is frame-relay connection between the 2 offices and is each connected by Cisco 1760. I have installed a MFT1 vic along with requisite DSP's and IOS upgrade. The PBX's each have a T1 trunk card installed. I now need to know how to configure the router to interface with the PBX. Do I configure T1 CAS and create dial-peers, or is there more to this? Any assistance given would be greatly appreciated.

Labels:
0 Helpful
2 Replies 2

norman.chen
Level 1
Level 1

‎11-23-2004 05:09 AM

Any ideas yet guys? I will really appreciate it. thanks

0 Helpful

markanthony
Level 1
Level 1
In response to norman.chen

‎11-29-2004 04:42 PM

have you made any progress with this? I'm just starting the same project here. Hopefully I'll have some news for you shortly. I'm tying to connect to my nortel key system which is pretty similar. I've installed an additional T1 card in the PBX and now will try and configure it as a PRI (not Nortel T1), configure the channels on my router, configure the routes on both sides and off to the races. I'm hopeful I can figure it out pretty quickly.

Have you made any progress?

0 Helpful
Customers Also Viewed These Support Documents