Hi,
1. i have CCM Ver 3.3(3) with latest Sr installed. My PSTN Gateway is a 2650XM with NM-HDV-2E1-60. I have config it as a ISDN PRI and is working fine.
2. After working for some time suddnly I get a line busy condition when try to connect out side. But incomming calls are working fine through the same channel. Find below debug out for this perticular disconnect incident, ext-298 calling a 033333333
*Mar 1 01:00:36.169: ISDN Se1/0:15 Q931: TX -> SETUP pd = 8 callref = 0x0004
Bearer Capability i = 0x8090A3
Standard = CCITT
Transer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98381
Exclusive, Channel 1
Display i = 'Server Room'
Calling Party Number i = 0x0081, '298'
Plan:Unknown, Type:Unknown
Called Party Number i = 0x80, '033333333'
Plan:Unknown, Type:Unknown
*Mar 1 01:00:36.213: ISDN Se1/0:15 Q931: RX <- STATUS pd = 8 callref = 0x8004
Cause i = 0x82E328 - Information element not implemented
Call State i = 0x01
*Mar 1 01:00:36.361: ISDN Se1/0:15 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x8004
Cause i = 0x82AC - Requested circuit/channel not available
Display i = 'REQUESTED CHANNEL NOT AVAILABLE'
3. 2600Xm is with the latest IOS , "flash:c2600-ipvoice-mz.123-11.T.bin"
4. When we connect the same E1 to a PABX, it works fine with no issue.
need suggestions ....
thanks
Arun
