We have some problem on configuaration PBX Matra 6550 in E1 primary-qsig :
2 PABX interconnect via WAN ( Working find in e&m wink-start )
sh isdn status
Global ISDN Switchtype = primary-qsig
ISDN Serial2/0:15 interface
dsl 0, interface ISDN Switchtype = primary-qsig
**** Slave side configuration ****
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI = 0, Ces = 9, SAPI = 16, State = MULTIPLE_FRAME_ESTABLISHED
Layer 3 Status:
1 Active Layer 3 Call(s)
CCB:callid=1, sapi=0, ces=0, B-chan=1, calltype=VOICE
Active dsl 0 CCBs = 1
The Free Channel Mask: 0x80000000
Number of L2 Discards = 11, L2 Session ID = 10
Total Allocated ISDN CCBs = 1
sh int serial 2/0:15
interface Serial2/0:15
no ip address
no logging event link-status
isdn switch-type primary-qsig
isdn incoming-voice voice
no cdp enable
sh controllers e1
E1 2/0 is up.
Applique type is Channelized E1 - balanced
No alarms detected.
alarm-trigger is not set
Version info Firmware: 20020812, FPGA: 11
Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (119 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Total Data (last 35 15 minute intervals):
3 Line Code Violations, 27 Path Code Violations,
1 Slip Secs, 0 Fr Loss Secs, 2 Line Err Secs, 0 Degraded Mins,
2 Errored Secs, 0 Bursty Err Secs, 1 Severely Err Secs, 0 Unavail Secs
When we try to call from handset phone we have a permanent tone .
