10-31-2004 10:31 PM - edited 03-13-2019 06:52 AM
Hi!
I have following setup : 1760-V-CCME/7970G/7960G7920G. My new VoIP ISP only communicate with SIP. What must I do to enable my setup for SIP. My VoIP is talking about STUN as well - What's STUN for ?
Thanx in advange
Tom Klitgaard
11-01-2004 08:27 AM
I guess all you need to do is,
dial-peer voice 1 voip
destination-pattern 9T
session protocol sipv2
session target ipv4:
STUN stands for serial tunneling and is a WAN L2 protocol.
11-02-2004 09:46 AM
Thanx for your reply. Very helpful.
Will I need to open some ports in my firewall (and what about NAT)
Thanx in advange
11-02-2004 12:04 PM
Does this help ?
11-02-2004 12:18 PM
Hi again "Shanky"
Yes it sure does - thanx a milion. I can see there it more, to the config of the pix, than I thourght in the first place.
Thanx again for taking your time it was again very helpful.
Tom
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide