--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note --
VG200, 2 VIC-2FXO-M2 cards, four ports total, all MGCP gateways on CCM 3.1.3(a). Have two straight POTS lines hooked into both ports on the VIC (I'm testing right now).
I have enabled caller ID on all of my FXO ports, but calls from the PSTN through the VG200 still show up as "External Call (Unknown Number)" on our IP phones. Yes, the lines are enabled for caller ID from the PSTN as well; that's why I'm puzzled as to why this isn't working. This is the first time I've set one of these up, so if there is an obvious solution, I apologize in advance. Any suggestions would be appreciated. My sh ccm, mgcp, and voice ports are below.
MGCP Domain Name: VG200A
Total number of host: 3
Priority Status Host
============================================================
Primary Registered 192.168.234.12
First backup Backup ready 192.168.12.12
Second backup Idle 192.168.134.12
Current active Call Manager: 192.168.234.12
Current backup Call Manager: 192.168.12.12
Redundant link port: 2428
Failover Interval: 30 seconds
Keepalive Interval: 15 seconds
Last keepalive sent: 20:31:19 (elapsed time: 00:00:12)
Last MGCP traffic time: 20:31:19 (elapsed time: 00:00:12)
Last switchover time: None
Switchback mode: Graceful
MGCP Admin State ACTIVE, Oper State ACTIVE - Cause Code NONE
MGCP call-agent: 192.168.234.12 Initial protocol service is MGCP, v. 0.1
MGCP block-newcalls DISABLED
MGCP send RSIP for SGCP is DISABLED
MGCP quarantine mode discard/step
MGCP quarantine of persistent events is ENABLED
MGCP dtmf-relay voip codec all mode out-of-band
MGCP dtmf-relay for VoAAL2 disabled for all codec types
MGCP voip modem passthrough mode: NSE, codec: g711ulaw, redundancy: DISABLED,
MGCP voaal2 modem passthrough mode: NSE, codec: g711ulaw
MGCP TSE payload: 0
MGCP Network (IP/AAL2) Continuity Test timer: 200
MGCP 'RTP stream loss' timer disabled
MGCP request timeout 500, MGCP request retries 3
MGCP gateway port: 2427, MGCP maximum waiting delay 3000
MGCP restart delay 0, MGCP vad DISABLED
MGCP simple-sdp DISABLED
MGCP codec type g711ulaw, MGCP packetization period 20
MGCP JB threshold lwm 30, MGCP JB threshold hwm 150
MGCP LAT threshold lmw 150, MGCP LAT threshold hwm 300
MGCP PL threshold lwm 1000, MGCP PL threshold hwm 10000
MGCP CL threshold lwm 1000, MGCP CL threshold hwm 10000
MGCP playout mode is adaptive 60, 4, 200 in msec
MGCP IP ToS low delay disabled, MGCP IP ToS high throughput disabled
MGCP IP ToS high reliability disabled, MGCP IP ToS low cost disabled
MGCP IP RTP precedence 5, MGCP signaling precedence: 3
MGCP default package: line-package
MGCP supported packages: gm-package dtmf-package trunk-package line-package
hs-package ms-package dt-package
MGCP VoAAL2 ignore-lco-codec DISABLED
Using 1442 out of 29688 bytes
!
version 12.1
no parser cache
no service single-slot-reload-enable
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname VG200A
!
logging rate-limit console 10 except errors
enable secret 5 --moderator edit-- nnnnnnnnnnn
enable password XXXXX
!
ip subnet-zero
no ip finger
!
mgcp
mgcp call-agent 192.168.234.12 service-type mgcp version 0.1
mgcp dtmf-relay voip codec all mode out-of-band
no mgcp timer receive-rtcp
call rsvp-sync
!
!
!
!
!
ccm-manager switchback graceful
ccm-manager redundant-host 192.168.12.12 192.168.134.12
ccm-manager mgcp
!
!
interface FastEthernet0/0
ip address 192.168.221.254 255.255.255.0
no ip mroute-cache
speed auto
full-duplex
!
ip classless
ip route 0.0.0.0 0.0.0.0 192.168.234.21
ip route 0.0.0.0 0.0.0.0 192.168.221.1
no ip http server
!
!
voice-port 1/0/0
station-id name pots1
station-id number 5683652
caller-id alerting ring 2
!
voice-port 1/0/1
station-id name pots2
station-id number 5683651
caller-id enable
!
voice-port 1/1/0
caller-id enable
!
voice-port 1/1/1
caller-id enable
!
dial-peer voice 1 pots
application mgcpapp
port 1/0/0
!
dial-peer voice 2 pots
application mgcpapp
port 1/1/1
!
dial-peer voice 3 pots
application mgcpapp
port 1/0/1
!
dial-peer voice 4 pots
application mgcpapp
port 1/1/0
!
dial-peer hunt 1
!
line con 0
transport input none
line aux 0
line vty 0 4
password XXXXX
login
!
end
TMH
