04-23-2012 08:12 PM - edited 03-15-2019 05:20 AM
I blew out a vsom stand vsms msp ru's so that I can have two stand alone boxes (both vsom & vsms on one box) one for lab and the other for production . .
One one box I am able to get it up and running on 6.3.2 on the other I have have created my raid0 drive and go to install and I keep getting an error message . . A profile for this machine could not be found . . (see pic) after which I enter the location of various partitions /dev/sda /dev/sdb /dev/sdc and it proceeds to the next step of creating partition plans and an error pops up and says "error while configuring partitions try again" . . I am unable to get the installation to complete . .
Has anyone seen this or know where I can go with this . .
I am trying to install on 5015B-MT, CIVS-MSP-1RU (where the vsom piece was originally) . . . Long story why I just didn't add the vsms part instead of blowing up
Sent from Cisco Technical Support iPad App
04-23-2012 11:24 PM
Hi,
I think it would be better that you post your question here: https://supportforums.cisco.com/community/netpro/security/physical-security
Regards,
- Adrian.
04-24-2012 06:27 AM
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide