'Command Parsing Failed'

[cex_teleco]

Hi,

we have 2 Nexus 5K (cisco Nexus5548 Chassis - System version: 5.1(3)N2(1)).

When we are trying to add new vlans to a Portchannel using switch-profile we get this message:

Error(s):

Following commands failed parsing: If the error is 'Command Parsing Failed', please check if some conditional feature(s) needs to be

enabled

switchport trunk allowed vlan 12, 14-15, 17-20, 24-27, 41, 45, 47-48, 50-51, 53-54, 56, 60, 64, 69-72, 75, 79, 82, 84-87, 89-91, 97,

99-100, 103-106, 108, 111-119, 121-122, 124-126, 138-142, 144-152, 173, 183, 188-190, 195, 197-198, 202-205, 207, 210-211, (Command

Parsing Failed)

Checking this document http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/troubleshooting/guide/n5K_trouble.pdf
(page 153), the solution is not specified. Which feature we have to enable?

Now, or features enbaled are:

Feature Name          Instance  State  

--------------------  --------  --------

fex                   1         enabled

interface-vlan        1         enabled

lacp                  1         enabled

lldp                  1         enabled

sshServer             1         enabled

telnetServer          1         enabled

udld                  1         enabled

vpc                   1         enabled

Regards.

[pille1234 · Accepted solution]

Hi,

it's a known bug: CSCua74057

As long as you don't work with Config sync it is a cosmetic bug only

[Tobias Hilbert]

Hi

We are using config-sync and running into this BUG alot.

Does anyone knows if this BUG is fixed in Versions after 7.1(4)N1

I looked through the BUG Search tool but could not find anything.

kind regards

Tobias