08-07-2014 03:03 AM - edited 03-01-2019 07:37 AM
Actually we have the diagram connectivity but when try to activated port-channel 70 the LACP is suspended and only on mode ON is possible the communication
ethernet 5/33 is down (suspended(no LACP PDUs))
admin state is up, dedicated interface
Show port channel summary
Flags: D-Down P-Up in port-channel (member)
I-Individual s-suspended
S-Switched
Group Port channel type protocol member port
------------------------------------------------------------------------------------------------
70 Po70(SD) Eth LACP Eth5/33(s) Eth5/34 (s)
Do you know something about this error, we try to force the negotiation on LACP but is the same error.
Best regards
08-07-2014 03:37 PM
Duplicate post.
Go here: https://supportforums.cisco.com/discussion/12273836/lacp-suspended-between-n7k-and-n2k
08-13-2014 06:36 AM
With FEX you use don't use the mode active.
Interface eth5/33
switchport mode fex-fabric
channel-group 70
The FEX uses a "Fabric" header on the link, and doesn't require LACP. You can use LACP on any host ports on the FEX, just not on the fabric links.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide