Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a management network where a Cisco MX device acts as the default gateway for my networks and is connected via a trunk port to a Cisco MS switch. When I manage the MS using DHCP from the MX, everything works fine. However, when I switch to a st...
Hi all
We have a trouble with connection to UCS C240 M3S that running CUCM with 1 Publisher and 4 Subscribers, on remote sites we are experimenting errors with features on transferencing, conferencing, in/out comming calls, we put a sniffer to monit...
Can i change the banner from telephone cisco 7942 and erase the directory number? Attached the image and red line show the DN that need to erase from display
Hi Actually we are implementing a network with a solucion VSS Catalyst 4500X the diagram is the follow: when I put on loop 2 ports on the same device the port doesn´t block and verifiying the spanning tree whe looking that port forwarding packets. We...
Hi Actually I´m installing the follow solution: I received all table routing for cloud on EDGE_VHS_1 RP/0/RSP0/CPU0:ED_VHR_1#sho ip routeFri Mar 13 17:24:13.680 UTCCodes: C - connected, S - static, R - RIP, B - BGP, (>) - Diversion path D - EI...
Hello thank you for your answersMy situation is there:My MX have default gateway for my vlans and DHCP only for Specific segments, i have a management vlan 90 and i have the following address192.168.90.1/28 Default Gateway for MX192.168.90.5/28 for M...
Hi Florian thamks for your responsewe had the control window and we can check the follow:We can move the first and only license on device generate between slots but the error change for slot e.g. Error on slot 3: LC/0/3/CPU0:Nov 26 19:06:20.958 : r...
