cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
987
Views
0
Helpful
1
Replies

Nexus 2k integration with 5K

sanjay.sangwan
Level 1
Level 1

Hi,

I used a portchannel between 5K and 2k but after defining the fex interfaces and associating with the port channel , the module is not added to

5K. I restarted the 5K and it adds up.I face the same with the 2nd 2k as well.Is there any other way to avoid the restart.

sanjay

1 Reply 1

Lucien Avramov
Level 10
Level 10

If you have vPC you need to make the changes on both 5ks.

If it's a single homed 5k, it should happen and no restart is needed. The show fex command takes some time, you can use the show fex # instead.

Review Cisco Networking for a $25 gift card