we want to deploy OTV in order to interconnect 2 active/active DCs , but we have multiple VRFs classifying the different SVIs (VLANs). We have 2 Nexus 7706 in each DC.
We would like to know if this would be supported.
VRF A --> Has SVI Vlan1,2
VRF B --> Has SVI Vlan3,4
Join interface that is Po100 to be virtualized into multiple logical sub-interfaces as many VRFs as we have, so:
vrf member A
vrf member B
and then configure 2 overlay interfaces in the same switch.
interface overlay 1
otv join-interface po100.1
otv extend-vlan 1-2 --> SVI in VRF A
interface overlay 2
otv join-interface po100.2
otv extend-vlan 3-4 --> SVI in VRF B
Traffic is always segregated and VRFs configuration is maintain. Note that the configuration is only showing the VRF part and it is not complete it.
Is this setup supported? in order to support VRFs we should do it differently? Here we are only showing one switch configuration and we would like to know if we would be able to load balance as we have 2 Nexus per DC.
Thanks a lot.