Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We are discussing about using the N3K-C3132Q-40GX or the N9K-C9332PQ. Our goal is performance. We can see that the 9332PQ performs a latency of less than 2 microsec, but we are not able to find the latency on the N3K-C3132Q-40GX. Do you guys know...
Hi, when deploying four ASA firewalls in cluster mode, the health check monitoring cannot be customized like for Active/Passive setup? For example, we don't want a FW member to leave the cluster if the management interface goes down. Another example ...
Hi,we want to deploy four firewalls in cluster in individual interfaces mode. Because we are using individual interfaces mode each interface will have a different IP address.As the site-to-site VPN is a non-cluster feature, VPN traffic will only be ...
Hi,We have an ASA 5585-X SSP40 that has 2 management ports 0/0 and 0/1.We have 2 Catalyst switches (switch1 and switch2) working as management switches and they carry the management VLAN.I was wondering if we could connect management 0/0 to switch1 a...
Hi, we want to deploy OTV in order to interconnect 2 active/active DCs , but we have multiple VRFs classifying the different SVIs (VLANs). We have 2 Nexus 7706 in each DC. We would like to know if this would be supported.ExampleVRF A --> Has SVI Vlan...
Hi, same issue here with the same OS version connection is open between the Cisco servers and our IPS. We are using a 5585-X SSP40 IPS module. If we find something I will let you know, but will probably downgrade again. thanks. Regards, J
Hi Karthik,that command looks very good for the solution I am looking for. My big question with the ASA cluster is if all the VPNs will be UP or only the VPN pointing the Master unit will be UP...But even if the 4th links are UP, the traffic will alw...
Hi Karthik, thanks for the answer I will need to think about it. from the ASA modes:- Active/Passive- Active/Active- CLuster (since 9.0 ASA) --> this is my cluster. Mine is between DCs inter-site cluster so since 9.1 Do you think it will work in my s...
Thanks a lot Marvin. I will then use a different VLAN for each management interface.I was thinking to channel them, but as our four ASA FWs are in cluster between DCs if we lose the management interface of one we will lose the management of all the A...
Thanks Jerry, you are right I was misunderstanding the OTV concept as traffic will not be mixed, it will stay layer 2 encapsulated inside layer 3 so no need for VRFs. I will just create an OTV VRF to isolate OTV traffic from the other type of traffic...
