Hello,
While checking the VPC consistency for layer 1 on a port-channel interface, the output shows that "Vlan xlt mapping" is enabled in the peer and not locally.
However my vPC is up and this mismatch is not being treated as an inconsistency.
Since we are going to migrate a service to this new C7010 pair, just want to confirm what this feature really means and is it going to affect when traffic goes live,
BIOS: version 2.12.0
kickstart: version 6.2(6)
system: version 6.2(6)
Mod Ports Module-Type Model Status
--- ----- ---------------------------------------------- -------------------------- ----------
1 24 10 Gbps Ethernet Module N7K-M224XP-23L ok
5 0 Supervisor Module-2 N7K-SUP2E active *
10 48 1/10 Gbps Ethernet Module N7K-F248XP-25E ok
sh vpc consistency-parameters vpc 527
Legend:
Type 1 : vPC will be suspended in case of mismatch
Name Type Local Value Peer Value
------------- ---- ---------------------- -----------------------
STP Port Type 1 Default Default
STP Port Guard 1 Default Default
STP MST Simulate PVST 1 Default Default
lag-id 1 [(1, 0-23-4-ee-be-66, [(1, 0-23-4-ee-be-66,
820f, 0, 0), (fa0, 820f, 0, 0), (fa0,
0-23-4-ee-be-1, 820f, 0-23-4-ee-be-1, 820f,
0, 0)] 0, 0)]
mode 1 active active
Speed 1 10 Gb/s 10 Gb/s
Duplex 1 full full
Port Mode 1 trunk trunk
Native Vlan 1 1 1
MTU 1 1500 1500
LACP Mode 1 on on
Interface type 1 port-channel port-channel
Admin port mode 1 trunk trunk
Vlan xlt mapping 1 Enabled -
vPC+ Switch-id 1 1001 1001
vPC card type 1 Clipper Clipper
Allowed VLANs -
Local error VLANs - - -
