1811W and OER

zoltnagy69 · ‎09-11-2005

Hi Guys,

I am working on a project that involves Optimized Edge Routing. I do not have access to TAC. Based on publicly available documentation the 1800 series platform supports OER.

I tried to configure an 1811W as a OER master and border on the same router but it does not take the oer border command.

oer ? only shows oer master as a valid command. Why? Is it not supported?

Does a 12.4 image support OER border on this model?

If not which lower-end model of Cisco router portfolio supports both?

Cisco IOS Software, C181X Software (C181X-ADVIPSERVICESK9-M), Version 12.3(8)YI1

, RELEASE SOFTWARE (fc1)

Synched to technology version 12.3(10.3)T2

Technical Support: http://www.cisco.com/techsupport

Compiled Fri 22-Apr-05 18:57 by ealyon

ROM: System Bootstrap, Version 12.3(8r)YH5, RELEASE SOFTWARE (fc1)

ROM: Cisco IOS Software, C181X Software (C181X-ADVIPSERVICESK9-M), Version 12.3(

8)YI1, RELEASE SOFTWARE (fc1)

Thanks in advance,

Zolt

pradeepde · ‎09-15-2005

All low end routes supports OER. but the problem may be due to IOS used . upgrading the IOS may support the oer command

zoltnagy69 · ‎09-19-2005

Thanks for the answer. In the meantime I found out from Cisco that the 1700 series all models and the 1841 support OER. 180x and 181x models do not fully support it, even with the latest image.