Re: 1841 With HWIC-1ADSL

phlitservices · ‎09-09-2006

Hi All,

I have problem where a newly purchased 1841 Router with base image will not recgonize an HWIC-1ADSL card. The error i'm getting when the router boots and the sh ver output is as follows:

0X00000000 UNKNOWN Card in slot 1

CARD_NOT_SUPPORTED: Slot 1: Unknown WAN daughter card

#sh ver

Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(1c), RELEASE SO

FTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Compiled Tue 25-Oct-05 17:10 by evmiller

ROM: System Bootstrap, Version 12.3(8r)T9, RELEASE SOFTWARE (fc1)

yourname uptime is 7 minutes

System returned to ROM by power-on

System image file is "flash:c1841-ipbase-mz.124-1c.bin"

Cisco 1841 (revision 6.0) with 114688K/16384K bytes of memory.

Processor board ID FTX1031Y02U

2 FastEthernet interfaces

DRAM configuration is 64 bits wide with parity disabled.

191K bytes of NVRAM.

31360K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102

Any assistance is appreciated..

Don

ajagadee · ‎09-09-2006

Don,

HWIC-1ADSL on 1841 is supported only on 12.4(4)T and higher. Please refer the below URL for details.

http://www.cisco.com/en/US/products/ps5853/products_data_sheet0900aecd80394b7e.html

I hope it helps.

Regards,

Arul

phlitservices · ‎09-09-2006

Thanks for your reply. I'll try an updated software image and see how it goes..

Don