2811 EtherSwitch Service Module

[markcole]

Trying to access a EtherSwitch Service Module within a 2811 , i believe the module runs its own ios, have found "service-module g x/y session command"

but am still having no joy any one out there come across this issue before

[mchin345]

There are no external interfaces on the Cisco Unity Express hardware (physically there is an FE interface port, but it is disabled in software and unusable)all access must pass via the host router. The only local access to the Cisco Unity Express system is therefore via the host router's console interface. Access to Cisco Unity Express (via the router's command-line interface [CLI]) is only possible by using the following command:

lab-2691#service-module

service-Engine x/y session

This command requires Enable mode on the router and is therefore protected by the router's enable password settings. Although there is also an "enable" mode in the Cisco Unity Express module CLI, it has no password capability.

This URL should help you:

http://www.cisco.com/en/US/netsol/ns340/ns394/ns165/ns391/networking_solutions_design_guidance09186a00801f8e31.html