09-18-2003 05:24 AM - edited 03-02-2019 10:26 AM
Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)
The above interface appears to work fine for a random interval usually between 20 mins & 5 hours before locking up.
Once locked all software interogation indicates that there isn't a problem but I can see the 'Local Alarm' LED lit and can see that channelised interfaces are in status up/down. Was thinking of reverting to IOS 11.1(20)AA!
A system 'reload' solves the problem for another few hours!
Have tried different cards and Routers with the same result!
Suggestions appreciated.
09-18-2003 05:36 AM
Hi,
Have you looked deeper into this? Using a sh Tech do see if there was anything to note? If you do downgrade go to a 11.3(4)T, which is the minium supported IOS for the 2600er.
Regards,
Corey
09-19-2003 12:56 AM
I've looked further into this and can see it has 1 memory error under controller 0 after the fault has occured. Everything else appears to be the same.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide