Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm thinking of upgrading my RME version 3.4 to 3.5 as I just got the latest copy of RME 3.5. What are the steps I need to take in order to make sure that I can successfully perform the upgrade process ?regards,Joseph
I am using a switches set up as a stack with full redundancy. Now If i lose one of my links the switches are still active and my management stn. does not know any better. So I need to know of a way to find out if any of the gbics have gone down. That...
a 3661 with nm-4t and a 2610 with wic-1t,connected via a 256k leased line,I use syslog soft to monitor the 36,recently,the following log must appear 5-10 time per day: %LINK-3-UPDOWN: Interface Serial1/0, changed state to down %LINEPROTO-5-UPDOWN: Li...
Hi,My CISCO 6509 Chasis shows very high CPU utilization.When I see the processes running, L3 aging process is causing the problem.sh proc cpuCPU utilization for five seconds: 98.40% one minute: 99.00% five mi...
Hello,We are looking for a network monitoring software for alarm reporting, link monitoring, device polling, …Most of our LAN/WAN network is made of CISCO switches and routers:- 1 central site : 2xCatalyst4000, 3xCatalyst3550, 2xR3640- 11 remote site...
Is anyone running ACS 3.1 on a Windows 2003 server ? I want to upgrade to ACS 3.1 but we are also upgrading our servers to 2003. I have read in the documentation that ACS will run on win 2K SP3 but there is not mention of win 2003.can anyone help.Tha...
Hello,Regarding a new network configuration I'm thinking about implementing storm-control (broadcast/multicast/unicast) on all user ports. Are there any recommended values you should use in case of 10/half, 100/full and 1000/full connection? Maybe ...
I need to restore some backed up information, documentation points towards "Restore Database" in VPN/Security Management Solution, but also indicates that this is only available if you have Management Center applications installed. I only have CWLMS ...
When Novell server goes down the port of catalyst 3550 it connects to goes to administratively down state. When Novell servers goes up port does not go up. Is it a bug or what?--------------------------------------------------cat3550-21#sh verCisco I...
3 Questions:1.I need to upgrade the IOS image on mt catalyst switches and Routers. I need to know if I should get a LD or wait for a GD. there is no specific application for whihc I need the new images, I just want to upgrade everything and need to k...
Is their any way or any network management software Cisco or non Cisco were we can automatically shut done user Ethernet port when it hits a predetermined bandwidth (around 70%) We are currently using Cisco 2900 and 5509.Thanks
HiI have found the following commands in IOS 12(2)11Tl2tp tunnel bearer capabilities all l2tp tunnel framing capabilities allhowever, there is no reference whatsoever at Cisco as for what their meaning is. Can anyone, please, provide me with any expl...
I am stacking 4 - 3550-48 switches together and I would like to run a 2-gig uplink to our core. Does the 3550 allow etherchannel between 2 of the 3550's and the core.Example - Port gig 0/1 on switch on, and Port gig0/1 on switch 2. Etherchannel the...
The catalyst 4003 switch can't be autoboot after power cycle~But i can be autoboot after hot reset by command "reset"~anybody meet the same question before?~thanks a lot~ZiXi Wei
