11-05-2001 03:13 AM - edited 03-01-2019 07:13 PM
I bought 3640 with nm-1fe2w. But it says "get_man_dev: Unknown device - probably NOT formatted." and the ouput of show diag is
Router#sho diag
Slot 3:
Unknown (type 215) port adapter, 0 ports
Port adapter is disabled
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware Revision : 1.0
Part Number : 800-04796-01
Board Revision : F0
Deviation Number : 5304-8707
Fab Version : 05
PCB Serial Number : JAD053301FR
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 00 D7 41 01 00 C0 46 03 20 00 12 BC 01
0x10: 42 46 30 80 14 B8 22 03 02 05 C1 8B 4A 41 44 30
0x20: 35 33 33 30 31 46 52 03 00 81 00 00 00 00 04 00
0x30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x40: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
IOs ver is 12.0.13
I appreciate who helps me
11-06-2001 03:54 AM
Hello ,
Just a guess (I don't have special knowledge or experience with that stuff) : did you check ALL requirements ?
According to the corresponding Data Sheet at: http://www.cisco.com/warp/public/cc/pd/rt/2600/prodlit/2636m_ds.pdf
* The minimum IOS rev required is 12.0.7(XK)
or 12.1(1)T - you say it's 12.0.13
* The minimum DRAM is 32MB +
700-1.5 MB of I/O Mem for each NM
If all requirements met, did you try another slot ? what's the result ?
Hope this helps.
11-06-2001 09:44 AM
Yap, I'm sure that the IOS version does support 2FE2W module. Seen before in one of my customer site, upgrade the IOS to 12.2 or go to cisco sales tool to check on the min. IOS that supports NM-2FE2W. Below is the link.. ;>
http://www.cisco.com/cgi-bin/front.x/Support/HWSWmatrix/hwswmatrix.cgi
11-06-2001 11:05 PM
Dear all,
As I am the person who asks the question, U found the solution.
As soon as I upgraded IOS ver 12.2.3Ip Plus I solve the problem.
As router has no ethernet port, I used Xmodem to upgrade IOS. It takes aproximately 3 hours.
thanks
11-22-2001 10:47 PM
Hi you are using the wrong IOS on the Router. Please refer to the hardware/software matrix. For the NM-1FE2W you need for a 3600:
NM-1FE2W= 12.0(7)XK, 12.1(1)T, 12.1(5)YB, 12.2(1), 12.2(2)T
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide