Hello All,
I was hoping one you you could help me with the following problem.
I have just configured a 3745 with a NM30DM and E1/PRI for accepting incoming async dialup users.
IP is working fine for dialup users, works a treat. However, I cannot say the same for IPX. When I dialin (Windows XP) I get an "Error 773"
Here's a "debug ppp negotiation" from the 3745:
03:40:22: As52 PPP: Phase is UP
03:40:22: As52 IPCP: O CONFREQ [Closed] id 1 len 10
03:40:22: As52 IPCP: Address 10.27.66.1 (0x03060A1B4201)
03:40:22: As52 IPXCP: I CONFREQ [Not negotiated] id 5 len 18
03:40:22: As52 IPXCP: Network 0x00000000 (0x010600000000)
03:40:22: As52 IPXCP: Node 02ee.0ef0.bdc7 (0x020802EE0EF0BDC7)
03:40:22: As52 LCP: O PROTREJ [Open] id 202 len 24 protocol IPXCP
03:40:22: As52 LCP: (0x802B01050012010600000000020802EE)
03:40:22: As52 LCP: (0x0EF0BDC7)
03:40:22: As52 CCP: I CONFREQ [Not negotiated] id 6 len 10
03:40:22: As52 CCP: MS-PPC supported bits 0x00000001 (0x120600000001)
03:40:22: As52 LCP: O PROTREJ [Open] id 203 len 16 protocol CCP (0x80FD0106000A120600000001)
And here's a snapshot of the 3745 config:
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname CISCO-RAS1
!
aaa new-model
!
!
aaa authentication login default group radius
aaa authentication ppp default if-needed group radius
aaa session-id common
enable secret yadayadayada
!
ip subnet-zero
!
!
no ip domain-lookup
!
ipx routing 0009.7ce3.a050
isdn switch-type primary-net5
!
!
!
!
!
!
!
fax interface-type fax-mail
mta receive maximum-recipients 0
!
controller E1 2/0
framing CRC4 Australia
pri-group timeslots 1-31
!
!
!
!
interface Loopback0
ip address 10.27.66.1 255.255.255.0
!
interface FastEthernet0/0
ip address 10.27.88.1 255.255.255.0
duplex full
speed 100
ipx network 102788D
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial2/0:15
no ip address
encapsulation ppp
isdn switch-type primary-net5
isdn incoming-voice modem
no cdp enable
!
interface Group-Async1
ip unnumbered Loopback0
encapsulation ppp
dialer in-band
dialer-group 1
async mode dedicated
ipx network 102766D
peer default ip address pool dialin
ppp authentication pap chap
group-range 33 62
!
ip local pool dialin 10.27.66.100 10.27.66.200
ip classless
ip route 0.0.0.0 0.0.0.0 10.27.88.254
no ip http server
ip pim bidir-enable
!
!
dialer-list 1 protocol ip permit
dialer-list 1 protocol ipx permit
!
!
!
!
!
!
radius-server host 10.27.1.1 auth-port 1645 acct-port 1646 key cisco
radius-server retransmit 3
call rsvp-sync
!
!
mgcp profile default
!
dial-peer cor custom
!
!
!
!
line con 0
line 33 62
modem InOut
line aux 0
line vty 0 4
password cisco
!
end
--------------------------------------------------------
Any help would be greatly appreciated.
