I need to create an L2 ethrchannel between my 6513's and a stack on Nortel 450 24T Layer 2 switches as part of my migration to an ALL Cisco solution. I've tried but cannot get the port-channel to come active, I would hope someone has done this before...
I am new to the VPN and networks, but from the documentation I can't see any way to let the VPN concentrator accept more than 1 conection from a public IP. Is it possable to do this? I would like to have more that one user connect via a DSL line to...
Good morning all :)Has anyone ever done this, and how can you do it?I would like to see Q.921 (LAPD) and Q.931 frames/formats and look at the addressing to the SP.Many thx indeed.Ken
Dear All ,I am looking for SNMP OID (.1.3.6.1.4.9.???? ) to get below router values by using simple SNMPWALK command .1. CPU Load .2. NVRAM size 3. ROM/RAM size 4. Mgmt TypePlease let me know the answer for the above Cisco snmp OID . Regards Senthil
A campus network with 3 no of Cat5505 and 2 no of Cat 5509 switches is running well. Each of the Cat5500 switches are having one Dual Phy LANE Module (WS-5168) installed. Now I want to monitor the switch status using Cisco View (Ver5.3). Problem is t...
I would like to verify that this scenario would work. Client has a T-1 circuit with 6 channels split out from an Adtran T-Mux for data to a V.35 serial interface on a router (not Cisco). Plan is to replace existing router with Cisco (1720 or 26xx) a...
Hello All,I was hoping one you you could help me with the following problem.I have just configured a 3745 with a NM30DM and E1/PRI for accepting incoming async dialup users.IP is working fine for dialup users, works a treat. However, I cannot say the...
We have had all static IPs in the past. To ease the "user experience" during a VPN implementation, we would like to have certain users obtain IP info with DHCP. Do I need a seperate DHCP server for the subnets? I have three subnet that are on the ot...
Hi,Currently I am working on project for school. In this project I have create a frame relay network with ISDN as backup with a 1700 (server) and a 2500 (client) router. I have frame relay up and running but the ISDN doesn't work.If I disconnect the ...
I heard that it would be easy for someone to mess up the whole HSRP process if they came in with a laptop that had Linux and with the use of some shell scripts they could listen for an HSRP multicast and then talk to any of those HSRP group #'s with...
I need to replace a Cabletron switch that has a gigabit interface (fibre) with a new switch (possibly from Cisco!). I also need to plug in about 60 100Mbit Ethernet hosts. Now I' ve got two Catalysts 1900 connected to the Cabletron that don't seem to...
Hi all,Is the command "ip pim accept-rp" just used with sparse-dense mode for accept the rp that auto selected? and must the command used with " ip pim send-rp-discovery" ? And does any body know where has sample config of this command? Thank You!Bes...
