11-15-2001 07:10 AM - edited 03-01-2019 07:24 PM
How can I check CPU utilization on 5505, not the RSM module but the switch side of it? I am running ver. 4.5. I am sorry I could not find it on Cisco's web site.
Thanks,
11-15-2001 07:27 AM
Ps -c
Remember it shows the utilization in reverse.
5505(enable) ps -c
CPU usage information:
Name CPU-Usage Invocations
--------------- --------- -----------
Kernel and Idle 97% 0
Flash MIB Updat 0% 165
runTimeDiag 0% 101
SynDiags 0% 4954
SynConfig 0% 36545334
In this case, it is 3 % utilized.
11-15-2001 09:36 AM
How did you get 3%? Is it 100%-97%?
Thanks,
11-15-2001 09:47 AM
yes sir :)
11-15-2001 09:53 AM
I am sorry for another question. Where did find this command? I've looked everywhere on Cisco's website and I couldn't find it.
Thanks again,
11-15-2001 10:11 AM
Well, this command is replaced with a generic "show processor cpu" in later codes (5.x)
It is mentioned in this URL
but i don't see much documentation for it. I work in TAC and so I had used it before.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide